The Official RAPID DIVER Forum
Please log in!

Join the forum, it's quick and easy

The Official RAPID DIVER Forum
Please log in!
The Official RAPID DIVER Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Rapid Diver Maintenance

Go down

How often should your Rapid Diver have a complete service?

Rapid Diver Maintenance I_vote_lcap100%Rapid Diver Maintenance I_vote_rcap 100% 
[ 7 ]
Rapid Diver Maintenance I_vote_lcap0%Rapid Diver Maintenance I_vote_rcap 0% 
[ 0 ]
Rapid Diver Maintenance I_vote_lcap0%Rapid Diver Maintenance I_vote_rcap 0% 
[ 0 ]
 
Total Votes : 7
 
 

Rapid Diver Maintenance Empty Rapid Diver Maintenance

Post by Rapid Diver Tue May 26, 2009 4:27 pm

Always read your owners manual!

Here are some tips:

1. Reload and readjust your straps after your dives.
2.Completely fill your Rapid Diver vest and let dry.
3.Flush out the bladder if you dive in salt water.
4.Check the dump valve connections on a regular basis (they like to loosen up in transit)
5.Make sure that you don't completely drain your tank underwater...if it happens make sure you get a proper VIP
6.Always have a spare valve O ring for yoke type valves and replace often.

Rapid Diver

Posts : 224
Join date : 2009-05-24
Location : Orlando

http://www.RapidDiver.com

Back to top Go down

Rapid Diver Maintenance Empty Disinfecting your equipment

Post by Rapid Diver Wed Jul 01, 2009 12:33 pm

It is important to sanitize your regulators after each dive. A simple way to do it is have 1 gallon bucket and some bleach. Use 1 capful per of bleach per one gallon of water . Soak your regulators for 10 minutes.

Here is a recent report about "Rinse Tanks"

Bacterial Contamination in Rinse Tanks
a new study says don’t dip your mask and regulator
from the June, 2009 issue of Undercurrent


Recreational divers typically rinse their equipment in “communal” tanks filled with fresh water after completing dives. Often all the equipment (wetsuits, booties, fins, BCDs, regulators with mouthpieces and masks) is rinsed in common tanks. In some facilities, a separate tank is provided for rinsing regulators. Masks are often rinsed and even stored in a common tank on boats before a dive.

Few studies have addressed the possibility that these communal rinse tanks may harbor pathogens and transmit disease. We first reported that communal rinse tanks at a dive facility in Roatan indeed contained significant levels of many types of microorganisms (Microbe, December 2007, p. 577). However, because that dive facility did not allow us to sample the water entering rinse tanks, we were unable to determine if the microorganisms originated from the water used to fill tanks or from equipment that was rinsed in the tanks.

Recently, a report documented the spread of conjunctivitis among divers using two dive boats off of Fiji’s Vitu Levu Island (Undersea and Hyperbaric Medicine, 2008 vol. 35, p. 169). Among 29 divers, 14 cases (almost 50 percent) of conjunctivitis were ultimately documented. The pattern by which conjunctivitis was spread among divers and between boats was consistent with the outbreak arising from the divemaster, a Fijian resident, who reported having an eye infection prior to the outbreak and who placed his own mask in the communal mask container (Undersea and Hyperbaric Medicine, 2008 vol. 35, p. 169). This study established that disease can be transmitted among scuba divers via communal tanks. (Read our interview with the study’s author in our September 2008 issue.)

In October 2007, we investigated the extent to which bacteria were introduced into communal rinse tanks, via water used to fill tanks and via dive equipment rinsed in them, and whether cleaning a rinse tank with bleach once a day reduced the subsequent bacterial population. A dive facility in Bonaire cooperated in this study but wished not to be identified.

Samples from boats returning from afternoon dives showed very high levels of many types of bacteria.

The facility had two rinse tanks for general equipment and one tank for regulators. Each morning for three days, at 7:30 a.m., one equipment rinse tank, designated “A” was emptied, scrubbed using undiluted bleach, then rinsed several times and filled with fresh water from a hose. The other equipment rinse tank, “B,” was emptied, rinsed several times with water and filled with water from the same hose but was not bleached. We did not empty, clean or fill the regulator rinse tank. During the day, dive staff would occasionally drain and refill equipment and regulator rinse tanks. Water samples were obtained from the three tanks three times daily: 8 a.m., 1 p.m. and 5 p.m. The samples were placed in a refrigerator until the day of departure, then put in a suitcase, placed in a refrigerator 12 hours later, and finally examined for colonies and photographed. Pictures of plates can be viewed as a PowerPoint presentation at http://www.hsc.wvu.edu/som/bmp/miller.asp - - click the “Bonaire 2007” link under the topic “Research.”

No bacterial colonies were observed from water samples filling the rinse tanks. The 8 a.m. water samples, immediately after equipment tanks were cleaned with bleach (A) or not cleaned with bleach (B) and filled with water, did not give rise to any colonies on all three days.

In contrast, 8 a.m. water samples in the regulator rinse tank contained a high level of bacteria on all days tested. Presumably the regulator rinse tank had been used to rinse regulators the previous day and after night dives. At 1 p.m. and 5 p.m., rinse tanks A, B and the regulator rinse tank usually showed high levels of bacterial contamination. Cleaning tank A with bleach did not reduce the subsequent bacterial level. In several instances, water samples showed low levels of bacteria -- this was apparently because the tanks had been recently drained and refilled. It was only possible to obtain water samples from two mask rinse tanks, both at 4 p.m., as boats were returning from afternoon dives. Both of these samples showed very high levels of contamination by many types of bacteria.

Our studies show that bacterial contamination of divers’ rinse tanks at this Bonaire facility was introduced by rinsing equipment, not by water used to fill tanks. Presumably, other potential pathogens, like viruses, are also introduced into the rinse tanks. If divers with a communicable illness (like conjunctivitis, the “common cold,” infectious mononucleosis, diphtheria and streptococcal infections) rinse equipment in a tank, people who rinse after them may pick up the transmitting microorganism and become infected.

We conclude that, if possible, scuba equipment, especially mouthpieces and masks, should be rinsed well with fresh water or alcohol swabs rather than in communal tanks, to reduce the potential of spreading or contracting disease. Studies are now in progress to identify the bacteria that inhabit the rinse tanks.

Michael R. Miller is a professor of biochemistry at West Virginia University, and Tammy S. Miller is senior office administrator of the department of microbiology and immunology at West Virginia University.

Forward this article to a dive buddy

Rapid Diver

Posts : 224
Join date : 2009-05-24
Location : Orlando

http://www.RapidDiver.com

Back to top Go down

Rapid Diver Maintenance Empty Keep you gear well maintained

Post by Rapid Diver Sat Dec 12, 2009 9:31 am

Feel free to contact me if you have any questions concerning the maintainance of your equipment. I am working with a scuba gear service facility in Florida that would be happy to service your gear.

PM or email if you are interested in getting pricing.

Chris@RapidDiver.com

Rapid Diver

Posts : 224
Join date : 2009-05-24
Location : Orlando

http://www.RapidDiver.com

Back to top Go down

Rapid Diver Maintenance Empty Re: Rapid Diver Maintenance

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum